Chapter 4: Commissioning the system 43
4.5 Advanced Settings
The Advanced Set Up features allow you to set the values for the following parameters
that affect the fine tuning of your radar:
Note:
Under normal circumstances you will not need to adjust these settings, as they are set
automatically at the factory. If these parameters are set incorrectly the performance of the ra-
dar will be adversely affected.
Adjusting the settings
You can adjust the advanced settings as follows:
1. Press MENU. The Set Up menu is displayed.
2. Use the trackpad up/down to highlight RADAR SET UP.
3. Press OK to select.
4. Use the trackpad up/down to highlight RADAR ADVANCED SET UP. The set up soft
keys will be displayed.
5. Press the corresponding soft key for the parameter you wish to adjust. The soft key
label is highlighted.
6. Use the rotary control to adjust the parameter value in the box above the soft key.
7. Press OK or use the rotary end push to accept the adjustment.
8. Repeat steps 5 through 7 to adjust next parameter.
The new settings will be retained by the display and be used the next time you power
up the radar.
Parameters Function
Display timing Corrects for display range error
STC preset Equalizes target levels across display
Tune preset Allows adjustment of the tuning range controlled by the TUNE control
D9014_1
AIS unit not available
i.e. not connected or off.
AIS unit switched on and
operating.
AIS unit switched on and
operating but dangerous &
lost target alarm disabled.
AIS unit on with active
alarm.
87020-3.book Page 43 Tuesday, March 7, 2006 11:02 AM
To Next Page
Loading...
