36 C-Series Displays Installation Manual
GPS
Check that the GPS has a clear view of the sky and is not obstructed e.g. by buildings,
bridges or other equipment fitted on-board.
Other equipment
For details of pre-start checks for other equipment e.g. AIS and Navtex receivers,
please refer to the relevant handbook.
4.3 Initial power on procedure
Once you have conducted the pre-start checks you are ready to start the display:
1. Press the POWER button until the introductory logo is displayed:
• The keys light up and after a few seconds a navigation warning is displayed.
• At this time the radar scanner (if fitted and powered) is checked for compatibil-
ity with the display. An error message is displayed if the scanner is incompati-
ble.
2. Read the warning and then press OK to remove it. The Select Page Set screen is dis-
played:
3. Use the trackpad to select the required page set and then press OK.
You are now ready to test that your system is receiving the necessary data to run all the
required applications.
D6577-1
D6655-3
87020-3.book Page 36 Tuesday, March 7, 2006 11:02 AM
To Next Page
Loading...
