Raymarine e7 - 10.4 Enabling AIS; 10.5 Displaying AIS vectors

10.4EnablingAIS
EnablingAISinthechartapplication
ToenableAISoverlayinthechartapplicationthechartviewmust
besetto2DMenu>Presentation>ChartView.
Fromthechartapplication:
1.SelectMenu.
2.SelectPresentation.
3.SelectLayers.
4.SelectAISOverlaysothatOnishighlighted.
SelectingAISOverlaywillswitchAISbetweenOnandOff.
EnablingAISintheradarapplication
Fromtheradarapplication:
1.SelectMenu.
2.SelectTrackTargets.
3.SelectAISTargetssothatOnishighlighted.
SelectingAIST argetswillswitchAISbetweenOnandOff.
10.5DisplayingAISvectors
YoumusthavethecorrectdataavailablebeforeAISvectorscan
bedisplayed.
Atargetisdenedasactivewhenithasthefollowingdatadisplayed
graphically:
•ACOG/SOGvectorindicatingthepredicteddistancethatatarget
willtravelwithinagivenperiodoftime.
•Aheadinganddirectionofturnindicator.
EnablinganddisablingAISvectors
Fromthechartorradarapplication:
1.SelectanAIStarget.
TheAIStargetcontextmenuisdisplayed.
2.SelectAISVector.
SelectingAISVectorwillswitchbetweenOnandOff.
Note:Thesametargetvectorandsafezonesettingsapplyto
bothradarMARPAandAIStargets.
UsingAIS
179