Raymarine RVM-100 - Mounting the Transducer

4.Usingapozi-drivescrewdriverandthescrewsprovided,securethe
transommountbrack
etusingthe2adjustmentslots.
Note:
Thethirdscrewisnotuseduntilthetransducerhasbeensuccessfully
tested.
Mountingthetransducer
Thetransducerismountedtothemountingbrack etusingthesuppliednut
andbolt.
Important:
•Onlyperformtheinstallationwithyourvesseloutofthewater .
•DoNOTliftorsuspendthetransducerusingitscable.
•DoNOTovertightenthebolt.Overtighteningmaycausedamageto
thetransducer.
Note:
Thescrewlocatedontopofthetransducerisusedwhenconnectingthe
transducertoamountingadaptorsuchastheS
tepmountbracket(A80479).
Y oudonotneedtoadjustthisscrewfortransommountinstallations.
1.Ensurethattheplasticchock(marked‘A’intheillustration)ispositioned
infrontofthetransducercable.Ifitisnot,pushthechockintothecorrect
position,aligningtheholeinthechockwiththeholesinthetransducer.
2.Positionthetransducerbetweenthearmsofthemountingbracket.
3.Aligntheholeinthetransducerwiththeholesinthemountingbracket.
4.Slidethemountingboltthroughtheholes.
5.Screwtheflangednylocknutontotheendofthemountingbolt.
28