Rayto RT-7600S - X-R QC Run; X-R QC List

RT-7600S Auto Hematology Analyzer User’s Manual
28
parameters. For instrument transfer terminal parameter setting, please refer to Chapter
7 “System Setting”.

Help: to display system help.

Exit: return to main screen.
4.3.2 X-R QC run
After QC parameter setting of selected QC file, QC analysis of this QC file can begin. In main
screen, select QC file, go to QC run screen, as shown below:
Fig.4-11 X-R QC run
1. Have QC sample ready, press Aspiration key to start test.
2. After test, QC results will be shown under current QC number column. If there is fault
alarm in test, this test result may be inaccurate. You can click “Delete” shortcut key to
delete this test result, eliminate related fault, before next test.
3. Each QC file can save at most (group numbers preset in QC setting × number of
samples in each group) QC results. Press “Exit” button to return to main screen.
4.3.3 X-R QC list
The instrument can look up X-R QC data by listing. In main screen, select QC file, go to QC
list, as follows: