RDS Technology Liftlog 1000 - Error Log; Pin; Software Reset

LIFTLOG 1000 – INSTALLATION AND CALIBRATION
35
3.4.6 Error Log
Logs the time and date of all error faults e.g. “P1” pressure sensor. This information can be cleared, printed, or saved to SD card /
USB stick.
3.4.7 PIN
You can change the factory default “Technician” menu PIN , and the “Factory” menu PIN.
NOTE: If the “Secure >0< Key” setting is enabled via “Sensor Setup”, then the “Factory” menu PIN is also that entered to access the “Set
Zero” routine on the main operating screen.
3.4.8 Software Reset
Resets all setup / calibration values and settings to the factory default settings.
Before doing a software rest, it is recommended to create a backup file of the above via the “Save to USB” screen in the Setup
menu, and save “All to HEX” (3.3.7).