LIFTLOG 1000 – INSTALLATION AND CALIBRATION
6
1. Introduction
1.1 Important Information
NOTE: FITTING, CALIBRATION AND MAINTENANCE MUST ONLY BE UNDERTAKEN BY A TRAINED INSTALLER. ANY ATTEMPT BY
UNQUALIFIED PERSONNEL TO INTERFERE WITH OR ALTER THE INSTALLATION OR SETUP OF THE SYSTEM, MAY RESULT IN
DAMAGE TO THE MACHINE, PERSONAL INJURY OR POSSIBLE DEATH!
This manual provides general guidelines that will enable the experienced installer to adapt the system successfully to the
majority of machine makes and models. If you are in any doubt regarding an installation detail for a particular machine, then
further technical guidance and specific installation detail is available from RDS Technology. Log in the website, or contact the
RDS Service and Support Department at the factory.
RDS Technology Ltd does not accept responsibility for faulty operation of the system or consequential damage, as a result of poor
workmanship of installation, or any aspect of component installation that does not comply with the requirements for correct
operation as stated in this manual. The installer is responsible to ensure proper fitting.
1.2 Important Safety Precautions !
In addition to observing site safety requirements, before working on the machine always :-
Make sure that the Attachment is down on the floor, and all pressure is released from the hydraulic system, before slackening
off any hydraulic coupling
Prevent the machine from being accidentally started while working on it e.g. remove the ignition key, place a warning notice
in the cab etc.
Keep other persons in the vicinity of the machine fully aware of your immediate intentions during installation and initial
calibration.
To Next Page
Loading...
Need help?
General