REA VERIFIER
© REA Elektronik GmbH, 64367 Mühltal, Germany --- REA MLV-2D Manual Version 3 – 21/12/2015
Page 24 of 98
4.10 Removing the coaxial lighting
The 90° coaxial lighting is mounted just like a base plate and is removed in the same
way. The lighting is connected to the REA MLV-2D with a cable and plug connector.
The connector must be unplugged carefully. A normal base plate must then be fitted,
as described in the previous section. The REA MLV-2D is therefore usable both with
and without 90° coaxial lighting.
The 90° coaxial lighting can be used only if this lighting was ordered together with the
device. Retrofitting the lighting is too complex and is not offered.
To Next Page
Loading...
