Need help?Do you have a question about the REA ScanCheck 3n and is the answer not in the manual?
General| Connectivity | USB |
|---|---|
| Type | Barcode Verification Device |
| Wavelength | 660 nm |
| Interface | USB |
| Storage Temperature | -20°C to 60°C |
| Power Supply | USB |
Covers essential safety precautions for operating the REA ScanCheck 3n.
Details potential electrical risks associated with the device and its power supply.
Highlights potential hazards and necessary precautions when using the REA ScanCheck 3n.
Covers the physical setup and initial hardware requirements for the device.
Explains how to connect the REA ScanCheck 3n to an external power source.
Describes the procedures for powering the device on, off, and managing sleep modes.
Details how to configure device parameters and customize settings.
Covers the use of the REA ScanCheck 3n with the TransWin32 PC software.
Provides an overview of the REA TransWin32 software and its installation.
Guides users through the process of updating the device's firmware and software.
Details various methods for connecting the REA ScanCheck 3n to a network.
Details connecting the device to a network using a DHCP server for automatic IP assignment.
Explains direct network connection between the device and a PC.
Describes how to connect the device using an Ethernet switch.
Covers connecting the device using a pre-configured default IP address.
Explains data communication setup when using an Ethernet switch.
Provides information on configuring the device's network IP addresses.
Instructions for configuring network settings directly on the REA ScanCheck 3n.
Details on setting network addresses using the REA TransWin32 software.
Overview of the importance and procedures for device adjustment and calibration.
Details the specific card required for device adjustment and calibration procedures.
Step-by-step guide for adjusting the device's measuring apertures (6, 8, 10 mil).
Explains the process of test equipment monitoring and calibration for accuracy.
Outlines the acceptable deviation ranges for device measurements according to standards.
Provides essential operating instructions for obtaining comparable and repeatable measurements.
Guides the user through the initial process of measuring bar codes with the device.
Describes the immediate feedback provided by LEDs and beeps after a measurement.
To Next Page
