To Next Page

To Previous Page

REA ScanCheck 3n

V 1.2.0 24/02/2020

REA VERIFIER

2.3 Dangers when handling the REA ScanCheck 3n

The REA ScanCheck 3n verifier has been designed in accordance with the state of the art and with

recognised safety rules, and is appropriately tested before delivery. Nonetheless, hazards to life

and limb of the user or of third parties, or impairments to the REA ScanCheck 3n or other property,

can come into being when it is used - in particular if this does not take place correctly. The

restrictions described in Chapter 14.4 must be complied with.

The REA ScanCheck 3n

 must be used only according to the intended use.

 and operated only when it is in perfect condition in terms of safety and security.

Faults that impair safety must be eliminated immediately

(see Chapter 8.6 Intended use).

In the case of faults, the REA ScanCheck 3n must be immediately shut down and is only allowed to

be started up again after proper repair!

The following warning signs are attached beneath the laser outlet window:

Warning signs:

Warning against laser beams

This symbol indicates a laser beam. Do not look into the laser beam!

Laser beam sign

Do not stare into beam! Class 2 Laser product

Caution:

In normal operation, the REA ScanCheck 3n verifier should be operated only

while standing, with the controls pointing upwards.

Warning:

Don’t cover the power supply unit (PoE injector) so as not to overheat it

REA ScanCheck 3n User Manual

Other manuals for REA ScanCheck 3n