Operating Manual Page 4 / 116 Copyright © REA Elektronik
REA ScanCheck 3n
V 1.2.0 24/02/2020
1 INTRODUCTION TO REA SCANCHECK 3N ............................................................................ 8
1.1 Scope of delivery of the REA ScanCheck 3n .................................................................... 9
1.2 Conditions for transport, storage and operation ............................................................ 10
1.3 Determining the serial number on the REA product ...................................................... 12
2 SAFETY INSTRUCTIONS ....................................................................................................... 13
2.1 General safety instructions .............................................................................................. 13
2.2 Electrical hazards ............................................................................................................. 14
2.3 Dangers when handling the REA ScanCheck 3n ............................................................ 15
3 COMMISSIONING THE REA SCANCHECK 3N ..................................................................... 17
3.1 Hardware installation ........................................................................................................ 17
3.1.1 Charging the rechargeable batteries .............................................................................. 17
3.2 Connecting the REA ScanCheck 3n to the mains power supply ................................... 19
3.3 Switching on and off ......................................................................................................... 20
3.3.1 <1> Sleep mode ............................................................................................................. 20
3.3.2 <2> Shut down device .................................................................................................... 20
3.3.3 <3> Reboot device ......................................................................................................... 21
3.3.4 <4> Terminate GUI ........................................................................................................ 21
3.3.5 <5> Reboot Verifier ........................................................................................................ 21
3.3.6 < 6> Login / Logout ........................................................................................................ 22
3.3.7 <7> Save system information / device data to USB ........................................................ 22
3.3.8 <8> Slide show ............................................................................................................... 22
3.3.9 Switching on again after a power failure ......................................................................... 22
3.4 Changing pre-settings on the REA ScanCheck 3n ......................................................... 23
3.4.1 Standard parameters for factory pre-settings ................................................................. 24
3.4.2 Changing the menu language selection.......................................................................... 24
3.4.3 Changing data output parameters .................................................................................. 25
3.5 Operating REA ScanCheck 3n with report printer .......................................................... 25
3.6 Operating the REA ScanCheck 3n with REA TransWin32 ............................................. 26
3.6.1 General information on the software installation ............................................................. 26
3.6.1.1 Software installation ................................................................................................. 28
3.6.1.2 Software and device options .................................................................................... 29
3.7 Updating the operating software in the REA ScanCheck 3n ......................................... 33
3.7.1 Updating the device from the USB stick with GUI ........................................................... 34
3.7.2 Updating the device from the USB stick with text console .............................................. 35
3.7.3 Updating the device with the Service Tool ...................................................................... 35
3.7.4 Updating the device with TransWin32 ............................................................................ 36
3.8 Network installation .......................................................................................................... 37
3.8.1 Connection via “DHCP” server in the network ................................................................ 37
3.8.2 Direct point-to-point connection ...................................................................................... 38
To Next Page
Loading...
Need help?
General
