To Next Page

To Previous Page

REA ScanCheck 3n

V 1.2.0 24/02/2020

REA VERIFIER

under the DHCP network can also be used. The use of fixed IP addresses is usually not required.

REA recommends either the fully automatic configuration by DHCP or ZeroConfig.

3.8.5 Data connection between the PC and REA ScanCheck 3n with an

Ethernet switch

If only a single network connection is available at the

workplace for the company network, then a network

switch must be interposed to be able to connect both

the PC and the REA ScanCheck 3n simultaneously

and in parallel with the computer network. The

connection corresponds with the connection

described under "Connection via DHCP server in the

network", or "Connection with default IP address”

with switch. In addition, in this constellation, the

switch is connected to the network socket in the room

for the company network with another network cable.

There is no need for further hardware installation.

3.9 Setting the network addresses

The network address of the REA ScanCheck 3n is set to an automatic address assignment at the

factory. If the REA ScanCheck 3n is operated in a company network with a DHCP server, this

server will assign a network address (IP address) to the REA ScanCheck 3n. In some cases, the

MAC address must be entered in the server.

REA ScanCheck 3n User Manual

Other manuals for REA ScanCheck 3n