To Next Page

To Previous Page

REA ScanCheck 3n

V 1.2.0 24/02/2020

REA VERIFIER

2 Safety instructions

2.1 General safety instructions

Before starting up the REA product and operating it, it is imperative for you to read and comply with

this Operating Manual and in particular the safety instructions very diligently. Additional information

and symbols are provided in the Appendix Fehler! Verweisquelle konnte nicht gefunden

werden..

Only trained personnel are allowed to start up,

operate and later service the device.

Prior to any maintenance work or other interventions, switch off the device and

pull the power supply.

Cleaning

Clean the housing only with a damp (not wet) cloth.

Only clean the lens and laser outlet window with a special cloth for optical lenses.

Attention: Cleaning with solvents destroys the device

Device protection is recommended in dusty environments. The device must be

protected from dust and covered, if possible.

ESD-sensitive components

Electrostatic discharges must be avoided. They can destroy the device.

Functional testing

It is recommended that test equipment be monitored regularly using the calibration

card supplied. (See chapter 4 Adjustment and calibration)

REA ScanCheck 3n User Manual

Other manuals for REA ScanCheck 3n