To Next Page

To Previous Page

REA ScanCheck 3n

V 1.2.0 24/02/2020

REA VERIFIER

4. Please wait for the ScanCheck 3n to restart (approx. 6 minutes). The device can restart in

the middle of the update procedure and resume the update. Once the update is complete, a

restart also takes place and the device then enters normal operating mode again.

5. Recalibrate the ScanCheck 3 device for 6 mil and 20 mil.

3.7.2 Updating the device from the USB stick with text console

Perform step 1 and step 2 as described in 3.7.1

3. Start text console

 <ON> button

 Button<4> (terminate GUI)

 Set the cursor to OK and confirm with the <OK ENTER> button

  The device now displays a black screen with white text.

4. Start update

 Button <6>

 Confirm with the <OK ENTER> button

5. Please wait for the ScanCheck 3n to restart (approx. 6 minutes). The device can restart in

the middle of the update procedure and resume the update. Once the update is complete, a

restart also takes place and the device then enters normal operating mode again.

6. Recalibrate the ScanCheck 3 device for 6 mil and 20 mil.

3.7.3 Updating the device with the Service Tool

1. Switch on the ScanCheck 3 device.

Close sleep mode / low power mode in the Scancheck 3n

 <Set-up> button

 Button <3> (settings)

 Button <4> (device configuration)

 Button <1> (operating modes)

 Deactivate the menu item “sleep/shutdown automatically”

 Confirm with the <OK ENTER> button

2. Connect the ScanCheck 3n with the PC.

3. From the CD or download area: In Setup.exe, go to “Current Verifiers”, then “SC3 Update”.

Now press the “SC 3 Update” button. The “ServiceTool” program is now started. The correct file for

the update has already been selected:

REA ScanCheck 3n User Manual

Other manuals for REA ScanCheck 3n