Operating Manual Page 41 / 116 Copyright © REA Elektronik
REA ScanCheck 3n
V 1.2.0 24/02/2020
3.9.1 Setting directly on the ScanCheck 3n device
The network address is set as standard to DHCP “ON” and Zero “ON”. Only if a fixed IP is to be
assigned manually can this be changed directly on the device via <Setup>, <3> Settings, <4>
Device configure, <5> Net configuration.
3.9.2 Setting via TransWin32
The network address can be set by the REA TransWin32 software. The setting can be found at
<Configure> <Others> <Device system>.
To Next Page
Loading...
Need help?
General
