To Next Page

To Previous Page

RED DSMC OPERATION GUIDE

955-0020_V5.1, REV-H | 100

points.

A line for each rack point displays, indicated by the letters A, B, C, and D. The focus distance displays for

each rack point.

8. If needed, select Re-Autofocus to run the autofocus algorithm, which resets the focus distance to the focus

distance calculated by the algorithm.

9. To set a rack point location, follow the instructions below:

A. Select the rack point that you want to set: A, B, C, or D.

B. Select Close to return to the main screen.

C. Press and hold the touchscreen LCD on the location where you want the rack point to be.

D. You can also press and drag the rack point to another location. In order to prevent a rack point from

being accidentally moved when touching it to rack focus to that point, the rack point is less sensitive

to touch than the other focus targets. If you need to fine-tune the location of your rack point, first drag

the rack point farther than it needs to be and then drag it to where you want it to be.

When you move a rack point, the camera autofocuses.

NOTE: To view the focus distance for each rack point on the main screen, go to Menu > Settings > Display

> Modes and enable Rack Target Distance mode. For more information about display modes, go to “Display

Modes” on page 51.

Questions and Answers:

Need help?

Do you have a question about the RED DSMC and is the answer not in the manual?

RED DSMC Specifications

General