To Next Page

To Previous Page

RED DSMC OPERATION GUIDE

955-0020_V5.1, REV-H | 99

ture is in Clean mode.

RACK TAB

Use the Rack tab to configure up to four focus points and execute rack focus between them.

SET UP RACK FOCUS

1. Ensure that a DSMC Nikon Mount, DSMC Canon Mount, or DSMC Canon MOTION MOUNT is installed and

that a supported lens is attached.

2. Go to Menu > Focus > Mode.

3. Select Rack from the Mode drop-down menu.

Spot is automatically selected from the Zone drop-down menu, since rack focus only works with Spot zone.

4. Select a size from the Size drop-down menu.

5. Go to the Rack tab.

6. Use the Rack Speed slider to change the speed at which the lens moves. Move the slider to the left for a

slower speed, and to the right for a faster speed.

7. Select the number of rack points you want from the Rack Points drop-down menu. You can select up to four

Questions and Answers:

Need help?

Do you have a question about the RED DSMC and is the answer not in the manual?

RED DSMC Specifications

General