COPYRIGHT © 2014 RED.COM, INC
RED DSMC OPERATION GUIDE
955-0020_V5.1, REV-H | 90
SELF TEST
When selected, allows you to perform a self-test for the sensor and LCD Touchscreen.
ENABLE/DISABLE SENSOR TEST PATTERN
This feature is currently only used during the manufacturing process.
When selected, enables/disables the sensor test pattern (White Screen). To turn on, select Enable Sensor Test
Pattern.
To turn off, select Disable Sensor Test Pattern.
TOUCHSCREEN
When selected allows you to perform a touchscreen self-test.
When the touchscreen self-test is on, you can verify all areas of the touchscreen respond to touch. Simply
touch each box using your finger. The touchscreen responds to the touch and the green box turns blue.
To exit the Touchscreen Self-Test:
1. Place your finger on the touchscreen and hold it there until the main screen appears.
2. Press the Enter or Menu button on the DSMC SIDE HANDLE or REDMOTE.
RESTORE SYSTEM
Restore System permits ALL camera configuration and setup data to be reset to factory default values.
When selected, you will be asked to confirm if you want to delete all settings and restore the factory default
settings. After settings are restored, the camera automatically powers down.
NOTE: User key settings will be reset as well as any other changes from the cameras default settings. The RED-
MOTE will also require pairing to communicate wirelessly with the camera.
REDISCOVER
Rediscovers all hardware and caches the data for future boot cycles.
When selected, you will be asked to confirm if you want to reset all hardware discovery settings. After settings
are reset, “RESET HARDWARE DISCOVERY SUCCESSFUL, INITIALIZING RESTART…” displays. The camera
automatically powers down and you will need to manually power it up.
To Next Page
Loading...
Need help?
General
