10A-39
ENGINE AND CYLINDER BLOCK ASSEMBLY
Sump: Removal - Refitting
K9K
10A
-the catalytic converter upstream strut bolts on
the catalytic converter (26 N.m).
a Tighten the catalytic converter upstream strut bolt on
the sump.
a Torque tighten the multifunction support lower
bolt (25 N.m).
a Refit the relay bearing of the front right-hand wheel
driveshaft.
a Torque tighten the front right-hand wheel drives-
haft relay bearing bolts (44 N.m).
a Refit the lower engine tie-bar (see 19D, Engine
mounting, Lower engine tie-bar: Removal - Refit-
ting, page 19D-33) .
a Fill up the engine oil (see 10A, Engine and cylinder
block assembly, Engine oil: Draining - Refilling,
page 10A-40) .
a Refit:
-the engine undertray,
-the dipstick,
-the engine cover.
To Next Page
Loading...
