Renault F9Q - Antipollution; Fuel Vapour Canister: Removal - Refitting

14A-1
ANTIPOLLUTION
Fuel vapour canister: Removal - Refitting
F4R or K4M
14A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove the fuel vapour absorber by pulling it
downwards then towards the vehicle exterior.
a Disconnect the fuel vapour absorber pipes (1) and
(2) .
a Insert the blanking plugs.
a Remove the fuel vapour absorber.
IMPORTANT
During this operation, be sure to:
- refrain from smoking or bringing red hot objects
close to the working area,
- be careful of fuel splashes when disconnecting the
union.
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
IMPORTANT
Wear goggles with side protectors for this opera-
tion.
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
WARNING
Keep the pipe unions away from contaminated
areas.
WARNING
To prevent impurities from entering the circuit, place
protective plugs on all fuel circuit components
exposed to the open air.
102483
102483