Renault F9Q - Page 873

19A-106
COOLING
Coolant temperature sensor: Removal - Refitting
F9Q
19A
REFITTING
I - REFITTING PREPARATION OPERATION
a Use SURFACE CLEANER (see Vehicle: Parts
and ingredients for the repairwork) (04B, Consu-
mables - Products) to clean and degrease the ma-
ting face of the coolant temperature sensor on the
coolant outlet unit.
a parts always to be replaced: coolant temperatu-
re sensor seal (10,06,01,18).
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
-a new seal on the coolant temperature sensor,
-the coolant temperature sensor,
-the coolant temperature sensor clip.
a Connect the coolant temperature sensor connector.
III - FINAL OPERATION
a Refit:
-the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
-the diesel injection computer (see 13B, Diesel in-
jection, Diesel injection computer: Removal -
Refitting, page 13B-17) ,
-the battery (see Battery : Removal - Refitting)
(80A, Battery),
-the engine cover.
a Fill and bleed the cooling system (see 19A, Coo-
ling, Cooling circuit: Draining - Refilling, page
19A-17) .