EasyManua.ls Logo

Renault F9Q - Page 90

Renault F9Q
993 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10A-84
ENGINE AND CYLINDER BLOCK ASSEMBLY
Multifunction support: Removal - Refitting
K4M
10A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove the front engine cover.
a Drain the refrigerant circuit using a refrigerant char-
ging station (see Coolant circuit Draining - Refil-
ling) (62A, Air conditioning).
a Remove:
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
-the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection).
a Remove:
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front section of the front right-hand wheel arch
liner (see Front wheel arch liner: Removal - Re-
fitting) (55A, Exterior protection).
a Remove:
- the engine undertray bolts,
- the engine undertray,
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-7) .
a Remove:
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the air deflectors,
-the headlights (see Front headlight: Removal -
Refitting) (80B, Headlights),
- the front bumper supports (see Front bumper
support: Removal - Refitting) (42A, Front upper
structure),
- the audible warning (see Horn: Removal - Refit-
ting) (82B, Horn),
- the front impact cross member (see Front impact
cross member: Removal - Refitting) (41A, Front
lower structure),
-the bonnet catch (see Bonnet latch: Removal -
Refitting) (52A, Non-side opening element mecha-
nisms),
- the engine wiring channel from the cooling fan as-
sembly.
Essential equipment
refrigerant charging station
Tightening torquesm
bolts 2 and 3 of the mul-
tifunction support
5 N.m
multifunction support
bolts (initial torque)
5 N.m
bolts 1, 5, 6, 4, 3, 2 of
the multifunction sup-
port
44 N.m
bolt 7 of the multifunc-
tion support on the
sump
25 N.m
K4M, and 858 or 866
K4M, and 848
K4M, and 858 or 866

Table of Contents

Related product manuals