Renault MASTER 2024 - Page 342

TYRES
6
340 - Practical advice
Position the jack 1 horizontally. The
head of the jack must line up with the
point 3 provided.
Rear jack support point 4 (rear-
wheeldriveandchassiscabver
sions)
This support point must be used when
changing the rear wheels for rear-
wheel drive and chassis cab vehicles.
Position the head of the jack against
the contact point 4 close to the wheel
concerned.
Position the jack 1 horizontally. The
head of the jack must line up with the
point 4 provided.
Startpumpingbymovingthethreeex
tension pieces 5 placed end to end,
available in the tool kit🡺334.
Free the wheel from the ground.
Note: using the three extension pieces
5 avoids having to go underneath the
vehicle to use the jack 1 when raising
the vehicle.
Remove the screws, then remove the
wheel (take off the central wheel trim if
necessary).
Fit the emergency spare wheel on the
centralhuband,dependingontheve
hicle, turn it to align the mounting
holes in the wheel and the hub.
Ifboltsaresuppliedwiththeemer
gency spare wheel, only use these
bolts for the emergency spare wheel.
Note: do not lubricate the wheel bolts
Topreventanyriskofin
juryordamagetotheve
hicle, only crank the jack
until the wheel you are
replacingisamaximumof3cen
timetres off the ground.