Renault MASTER 2024 - Page 343

TYRES
6
Practical advice - 341
Tighten the nuts and lower the jack.
With the wheel on the ground, tighten
theboltscompletely,followingtheor
der of tightening below:
Wheel with 6 holes: start with bolt A ,
then D , B , E , C and end with F .
Wheel with five holes: start with bolt
G , then J , H , K , and end with I .
Have the tightening and the pressure
of the spare wheel checked as soon as
possible.
Jack
If the vehicle is parked
on the hard shoulder,
you must warn other
road users of your
vehicle's presence with a warning
triangle or with other devices as
per the legislation applying to the
country you are in.
Switch on the hazard
warning lights.
Keep the vehicle away
fromtrafficandonalev
el surface where it will not slip.
Applytheparkingbrakeanden
gage a gear (first or reverse, or in
position D, M or R for automatic
transmissions).
Ask the passengers to leave the
vehicle and to keep away from
traffic.
For your safety, the use
ofajacknotrecom
mendedbythemanufac
turer is strictly prohibited.
The jack is specific to the vehicle
and used to change the wheels.
Under no circumstances should it
be used:
– on another vehicle;
– to carry out a repair;
– to access the underside of the
vehicle.
Risk of injury.
Risk of damage to the vehicle.