STARTING, STOPPING THE ENGINE
3
182 - Driving
The card must be in detection zone
1
for the van version or in detection zone
2
for the combi version.
Press button
3
.
To start:
– onavehiclewithanautomaticgear
box, set the lever to P or N position,
press the brake pedal and then press
the button
3
;
– on vehicles with a manual gearbox,
press the brake pedal or clutch and
press button
3
. If a gear is engaged,
thevehiclemayonlybestartedbyde
pressing the clutch pedal.
Special note:
– if any of the starting conditions are
not met, the "Press brake + START" or
"Press Clutch + Start" or "SelectGear
box Position "P"" message is displayed
on the instrument panel;
– in some cases, it will be necessary
to move the steering wheel whilst
pressing the start button
3
tohelpun
lock the steering column: in this case
the "Turn Steering Wheel + START"
message will inform you;
– when starting the engine in very low
exterior temperatures (below -10°C):
hold down the clutch pedal or the
brake pedal until the engine starts.