ResMed AIRMINI Clinical Guide

18
Disconnecting the AirMini tubing
For F20 only
Disconnect the F20 connector from the AirMini
tubing by gently twisting it and pulling it apart.
For N20 and AirFit P10 for AirMini only
Disconnect the vent module from the AirMini
tubing by gently twisting and pulling it apart.
Removing the HumidX or HumidX Plus
For N20 and AirFit P10 for AirMini only:
1. Disconnect the mask tube from the vent
module by gently twisting and pulling the two
apart.
2. If a HumidX or HumidX Plus is being used,
remove it from the vent module.
Note: The HumidX and HumidX Plus cannot be
washed.
Disconnecting the AirMini tubing
Disconnect the AirMini tubing from the machine by pressing the side buttons on the cuff and pulling
it away.
Unplugging the machine
Unplug the power supply unit from the power outlet and the machine.
Note: For mask disassembly instructions, refer to the mask user guide.

ResMed AIRMINI Specifications

General

Type	Travel CPAP machine
Pressure Range	4-20 cm H2O
Noise Level	30 dBA
Bluetooth	Yes
Operating Mode	CPAP, AutoSet
Sound Level	30 dBA
Altitude Adjustment	Automatic
Operating Temperature	41°F to 95°F (5°C to 35°C)
Weight	0.66 lbs
Power Supply	AC 100-240V, 50-60Hz
Humidification	Optional, with HumidX/HumidX Plus waterless humidification
Data Storage	Via AirMini app
Power Consumption	6.3W
Ramp Time	0 to 45 min (5-minute increments)
Compatible Masks	AirFit P10, AirFit N20, AirFit F20
Operating Humidity	10 to 95% relative humidity, non-condensing