Response Alarms SA3 - Part-Arm Configuration; Zone Lockout Configuration; Entry;Exit Warning Tone

24
Default setting: 3 minutes
Press ,
The zone LED corresponding to the current setting will
illuminate.
0 no alarm
1 1 minute
2 2 minutes
3 3 minutes
4 5 minutes
5 10 minutes
To change the setting:
Press the key corresponding to the required alarm
period, the corresponding zone LED will illuminate
as the setting is changed.
Note: When set to ‘No alarm’ the Siren will sound
for approximately 10 seconds if an alarm condition
is triggered.
Press to save the new setting and exit to
Program Mode, or
Press to exit without saving.
PART-ARM
This controls which zones are operational when the
Part-Arm feature is activated.
Default setting: zones 1-4: Enabled
5-6: Disabled
Press ,
The zone LEDs corresponding to the zones currently
active during Part-Arm mode will be illuminated. LEDs
for zones disabled during Part-Arm will be OFF.
LED ON Zone enabled in Part-Arm
LED OFF Zone disabled in Part-Arm
To change the setting:
Press the button corresponding to the zone
number to be changed. The zones status will
switch to the opposite state (enabled/disabled)
each time the button is pressed.
Press to save the new setting and exit to
Program Mode, or
Press to exit without saving.
ZONE LOCKOUT
This feature if enabled, will only allow a single zone
to trigger an alarm up to 3 times before the system is
disarmed. However, if this feature is disabled there is
no limit on the number of times a zone can trigger an
alarm condition.
Default setting: ON (enabled)
Press ,
The zone 1 LED will illuminate to indicate the current
Zone Lockout status.
LED ON Zone Lockout enabled
LED OFF Zone Lockout disabled
To change the setting:
Press .
The Zone Lockout status will switch to the opposite
state (enabled/disabled) each time the button is
pressed.
Press to save the new setting and exit to
Program Mode, or
Press to exit without saving.
ENTRY/EXIT WARNING TONE
This allows the warning beeps which are generated
during the entry/exit delay to be switched ON or OFF
as required.
Default setting: ON (enabled)
Press ,
The zone 1 LED will illuminate to indicate the current
status of the Entry/Exit warning tone.
LED ON Tone enabled
LED OFF Tone disabled
To change the setting:
Press .
The warning tone status will switch to the opposite
state each time the button is pressed.
Press to save the new setting and exit to
Program Mode, or
Press to exit without saving.