6
possible that it may detect other local radio interference
operating legally or illegally on the same frequency. If
it is planned to operate the Jamming Detection feature
we recommend that the system is monitored for false
jamming alarms for at least 2 weeks prior to leaving the
Jamming Detection function permanently enabled.
Note: The Jamming Detection features incorporated
into the Control Panel and Solar Siren operate
independently.
BATTERY MONITORING
All devices powered by non-rechargeable batteries
incorporate a battery level monitoring feature which will
warn of a low battery status.
In addition the Control Panel will also indicate a low
battery status on any PIR (Passive Infra-Red) or
Magnetic Contact Detector on the system.
The batteries on any device indicating a low battery
status should be replaced immediately.
SYSTEM HOUSE CODE
In order to prevent any unauthorised attempt to
operate or disarm your system, you must congure
your system to accept radio signals only from your own
system devices. This is done by setting a series of 8
DIP switches in all devices (except the Control Panel)
to the same ON/OFF combination (the House Code)
selected by the user/installer. The Control Panel is
then programmed to operate only with devices set to
this House Code.
The House Code is set up by moving each of the 8 DIP
switches in each device to the same randomly selected
ON/OFF sequence. When setting the DIP switches,
ensure that each switch ‘clicks’ fully into position. Use
the tip of a ballpoint pen or a small screwdriver to move
(or leave) each switch in turn.
IMPORTANT: It is important that the system House
Code is always changed to a code other than the
factory setting and that all devices are congured
with the same House Code in order for the system
to operate correctly.
To Next Page
Loading...
