Select the desired programme memory position under the item "Program" (H6.3).
Define the desired parameters ( Chapter "Adjustable Parameters" and "Activatable or
Deactivatable Parameters").
7.6.3 Save a Programme
Select "Save" to overwrite the selected programme memory position with the set
parameters.
To cancel the process, select "Back".
7.6.4 Delete a Programme
In programme mode, navigate to the menu item "Delete program".
Press the rotary push button to confirm the selection and to enter the submenu "DELETE
PROGRAM".
In the submenu "DELETE PROGRAM", the parameters of the active or any other
programme memory position can be deleted. The parameters of the operating mode "Quick
start" cannot be deleted.
NOTICE Although, in "Quick start" mode, the submenu "DELETE PROGRAM" is displayed in
grey, it is not accessible.
Select the desired programme memory position under the item "Program".
Select "Delete" to delete the sieving parameters in the selected programme memory
position.
To cancel the process, select "Back".
After clearing the settings, the sieving time, the speed and the negative pressure of this
programme memory position are set to zero and the open mesh function is deactivated.
7.7 Basic Settings
The following menu items can be accessed in the basic settings:
Neg. pressure
Languages
Brightness
Date
Time
Signal tone
Interface
Service
The individual functions are described in detail in the following subchapters.
7.7.1 Negative Pressure
The negative pressure can be displayed either in Pascal (Pa), millibar (mbar) or pound-force per
square inch (psi).
Use the rotary push button (H4) to navigate to the menu item "Neg. pressure". The
parameter is highlighted in a darker background.
To Next Page
Loading...