Retsch AS 200 jet - Page 59

Index
59
connection ....................................................... 29
Information note
H45 .................................................................. 44
Information notes ................................................ 44
Installation ........................................................... 14
Installation height ................................................ 15
Installation of the device ..................................... 17
Installation site
conditions ........................................................ 15
Interface .............................................................. 40
RS232 ............................................................. 40
USB ................................................................. 40
L
Languages .......................................................... 39
L
eq
....................................................................... 11
Location requirements ........................................ 12
Long-term operation ........................................... 27
M
Mains connection ................................................ 29
Mains frequency ................................................. 16
Mains supply ....................................................... 16
Mains switch ....................................................... 29
Maintenance .................................... 10, 45, 46, 48
Manometer .......................................................... 49
Manual ........................................................ 6, 8, 10
Manual mode ................................................ 33, 35
Manual vacuum regulation
adjustment ....................................................... 20
connecting ....................................................... 20
functional principle .......................................... 19
Manufacturer’s address ...................................... 16
Materials ............................................................. 26
Measurement range ............................................ 13
Measurement report ........................................... 43
N
Navigation ..................................................... 32, 33
Neg. pressure ............................................... 33, 34
Negative pressure ......................................... 13, 38
control range ................................................... 52
maximum ......................................................... 13
Negative pressure range .................................... 52
Negative pressure sensor ................................... 41
Notes on the manual ............................................. 6
Nozzle ................................................................. 28
Nozzle chamber .................................................. 28
Number of fuses ................................................. 16
O
Open Mesh ......................................................... 34
Operating controls .............................................. 32
Operating hours .................................................. 41
Operating instructions ......................................... 10
Operating mode
change............................................................. 33
manual............................................................. 33
programme ...................................................... 33
quick start ........................................................ 33
selection ......................................................... 33
Operating modes ............................................... 33
Operating the device .......................................... 26
P
Packaging .......................................................... 14
Parameter
save ................................................................ 35
Part number ....................................................... 16
Particle distribution ............................................. 43
Particle size analysis .......................................... 43
Particle size characteristics ............................... 43
Particle size distribution ..................................... 26
Particle size range ............................................. 13
Payload .............................................................. 13
Performing a sieving .......................................... 30
Power version .................................................... 16
Pressure sensor
calibration ....................................................... 48
Principle of operation ......................................... 27
Process
start................................................................. 36
start with Quick start ....................................... 37
stop ................................................................. 36
Programme
deleting ........................................................... 38
editing ............................................................. 37
saving ............................................................. 38
selecting ......................................................... 37
Programme memory position ............................. 37
Programme mode .................................. 33, 35, 37
Q
Quick start
assign parameters .......................................... 36
Quick Start ......................................................... 36
QUICK START ................................................... 33
R
Range of application of the device ..................... 27
Rated power ....................................................... 11
Receptacle ......................................................... 53
Receptacle volume ............................................ 12
Relative humidity
maximum ........................................................ 15
Repair ...................................................... 9, 45, 48
Repair instructions ..................................... 6, 9, 48
Required floor space .......................................... 12
Return ................................................................ 14
for service and maintenance .......................... 45
Return device ..................................................... 57
Return form ........................................................ 45
Revision status ..................................................... 6
Rotary push button ....................................... 28, 33
RS232 interface ................................................. 29
S
Safety instruction ................................................. 7
caution .............................................................. 7
danger .............................................................. 7