POP 3D Scanner User Manual
21 COPYRIGHT ©2021 REVOPOINT 3D ALL RIGHTS RESERVED
or save.
Continue Scan
·
Continue Scan After Mesh :
It is possible to continue scanning an object after the point cloud data has been meshed. This can be necessary if the scanning controller (a
computer or smartphone) runs out of RAM to capture more frames or if holes in the scan data are discovered. Don't forget to close the RGB
mode before continuing. This process can be repeated as needed until the model meets your requirements.
·
Open a model file
to scan over holes:
3D model files with defects can be fixed by continuing the scanning process:
To Next Page
Loading...
