Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699959
enquiries@hyquip.co.uk
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
www.hyquip.co.uk/web/index
Safety instructions 13/60
RE 92100-01-B/09.2012, A4VSG Series 10, 11 and 30, Bosch Rexroth AG
CAUTION
High noise development in operation!
Danger of hearing damage, deafness!
The noise emission of axial piston units depends on speed, operating pressure and
installation conditions. The sound pressure level may rise above 70 dBA during
normal application conditions.
▶ Always wear hearing protection when in the vicinity of the operating axial piston
unit.
Hot surfaces on the axial piston unit!
Risk of burns!
▶ Allow the axial piston unit to cool down sufficiently before touching it.
▶ Wear heat-resistant protective clothing, e.g. gloves.
Improper routing of cables and lines!
Tripping hazard and damage to equipment!
▶ Lay cables and lines so that they can not be damaged and nobody can trip over
them.
Contact with hydraulic fluid!
Hazard to health/health impairment e.g. eye injuries, skin damage, toxication during
inhalation!
▶ Avoid contact with hydraulic fluids.
▶ When working with hydraulic fluids, strictly observe the safety instructions
provided by the lubricant manufacturer.
▶ Use your personal protective equipment (e.g. safety glasses, safety gloves,
suitable working clothes, safety shoes).
▶ If hydraulic fluid should, nevertheless, come into contact with your eyes or
bloodstream or is swallowed, consult a doctor immediately.
Escaping hydraulic fluid due to machine/system leakage!
Risk of burns and risk of injury due to escaping oil jet!
▶ Depressurize the machine/system and repair the leak.
▶ Never attempt to block or seal the leak or oil jet with a cloth.
2.7 Personal protective equipment
The personal protective equipment is the responsibility of the user of the axial piston
unit. Observe the safety regulations and provisions of your country.
All components of the personal protective equipment must be intact.
To Next Page
Loading...
