REXROTH A4VSG - 6 Transport and Storage; Transporting the Axial Piston Unit; Transporting by Hand; Transporting with Lifting Device

Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699959
enquiries@hyquip.co.uk
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
www.hyquip.co.uk/web/index
Transport and storage 21/60
RE 92100-01-B/09.2012, A4VSG Series 10, 11 and 30, Bosch Rexroth AG
6 Transport and storage
▶ Always observe the required ambient conditions for transport and storage, see
chapter6.2 "Storing the axial piston unit" on page23.
Notes on unpacking can be found in chapter7.1 "Unpacking" on page26.
6.1 Transporting the axial piston unit
The transportation options below exist depending on the weight and duration of the
transport:
t Transport by hand (chapter not relevant for this axial piston unit)
t Transporting with lifting device (ring screw or lifting strap)
Table 6: Dimensions and weights
Size 40 71 125 180 250 355 500 750 1000
Mass
approx.
1)
kg 42 60 107 112 220 235 335 500 644
Width mm The dimensions vary with the unit type. The values applicable for your axial
piston unit can be found in the installation drawing (request if necessary).
Height mm
Depth mm
1)
Axial piston unit with HS4 control without valve block.
The weight specifications may vary depending on the unit type.
6.1.1 Transporting by hand
Axial piston units with a weight of up to 15 kg can be transported manually for
a short time if necessary.
CAUTION! Danger from heavy loads!
There is a danger of health damage when carrying axial piston units.
▶ Use suitable lifting, placement and relocation equipment.
▶ Use your personal protective equipment (e.g. safety glasses, safety gloves,
suitable working clothes, safety shoes).
▶ Do not transport the axial piston unit at sensitive attachment parts (e.g. sensors
or valves).
▶ Carefully place the axial piston unit on the seating to prevent it from being
damaged.
6.1.2 Transporting with lifting device
For transport, the axial piston unit can be connected with a lifting device to a ring
screw in the housing (from size 500) or to a drive shaft. Alternatively, transport is
also possible with a lifting strap.
Only use the lifting strap if you are unable to achieve the required installation
position with transport using the ring screws.
Dimensions and weights