REXROTH A4VSG - Safety instructions; 2.2 Intended use; 2.3 Improper use; 2.5 General safety instructions

Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
+44 (0)1204 699959
enquiries@hyquip.co.uk
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
www.hyquip.co.uk/web/index
RE 92100-01-B/09.2012, A4VSG Series 10, 11 and 30, Bosch Rexroth AG
3/60 Contents
Contents
1 About this manual 5
1.1 Validity of the documentation 5
1.2 Required and supplementary documentation 5
1.3 Display of information 6
1.3.1 Safety instructions 6
1.3.2
Symbols 7
1.3.3 Designations 7
1.3.4 Abbreviations 8
2 Safety instructions 9
2.1 About this chapter 9
2.2 Intended use 9
2.3 Improper use 9
2.4 Personnel qualifications 10
2.5 General safety instructions 10
2.6 Product-specific safety instructions 11
2.7 Personal protective equipment 13
3 General instructions on damage to equipment and the product 14
4 Delivery contents 17
5 About this product 18
5.1 Performance description 18
5.2 About this product 18
5.2.1 Assembly of the axial piston unit 18
5.2.2 Functional description 19
5.3 Product identification 20
6 Transport and storage 21
6.1 Transporting the axial piston unit 21
6.1.1 Transporting by hand 21
6.1.2 Transporting with lifting device 21
6.2 Storing the axial piston unit 23
7 Installation 26
7.1 Unpacking 26
7.2 Installation conditions 26
7.3 Installation position 28
7.3.1 Below-reservoir installation (standard) 29
7.3.2 Above-reservoir installation 30
7.4 Installing the axial piston unit 31
7.4.1 Preparation 31
7.4.2 Dimensions 32
7.4.3 General instructions 32
7.4.4 Installation with coupling 32
7.4.5 Installation on a gearbox 33
7.4.6 Installation with cardan shaft 33
7.4.7 Completing installation 34
7.4.8 Hydraulically connecting the axial piston unit 35
7.4.9 Electrically connecting the axial piston unit 41
7.5 Peforming flushing cycle 42