• You can change the machine's default [Density] setting to always scan with a specific density level.
For details, see page 214 "Scanner Features Settings".
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Reset Timer] or [System
Auto Reset Timer] while the initial screen is displayed. For details, see page 241
"Administrator Tools Settings".
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
Specifying Resolution
This section describes how to specify the scan resolution for the current job.
There are six resolution settings. The higher the resolution, the higher the quality but greater the file size.
1. Press the [Home] key.
2. Press the [Scanner] icon on the [Home] screen.
3. Press the [USB] tab.
4. Press [Scan Setting].
You can press [Scan Setting] only when you have selected the [USB] tab.
5. Press [Resolution...].
6. Select the desired resolution, and then press [OK].
7. Confirm the resolution you selected is displayed, and then press [OK].
5. Scanning Originals
160
To Next Page
Loading...
