Ricoh 132 MF - Page 245

Item Description Value
System Reset
Timer
Sets the machine to return to
the mode specified in
[Function Priority].
This setting is also applied to
the timeout for copying the
next document while ID card
copy and manual 2-sided
copy is performed.
• Off
• 30 sec.
• 1 min.
• 2 min.
• 3 min.
• 5 min.
• 10 min.
Default: [1 min.]
Energy Saver
Mode
Sets the machine to enter
Energy Saver mode, Energy
Saver mode 1 or Energy
Saver mode 2, to reduce
power consumption. The
machine recovers from
Energy Saver mode when it
receives a print job, prints a
received fax, or one of the
keys on the control panel is
pressed.
• Energy Saver Mode 1
The machine enters Energy Saver mode 1 if
the machine has been idle for about 30
seconds. It takes less time to recover from
Energy Saver mode 1 than from power-off
state or Energy Saver mode 2, but power
consumption is higher in Energy Saver mode 1
than in Energy Saver mode 2.
• Off
• On
Default: [Off]
Energy Saver
Mode
Sets the machine to enter
Energy Saver mode, Energy
Saver mode 1 or Energy
Saver mode 2, to reduce
power consumption. The
machine recovers from
Energy Saver mode when it
receives a print job, prints a
received fax, or one of the
keys on the control panel is
pressed.
• Energy Saver Mode 2
The machine enters Energy Saver mode 2
after the period of time specified for this setting
is passed. The machine consumes less power
in Energy Saver mode 2 than in Energy Saver
mode 1, but it takes longer to recover from
Energy Saver mode 2 than from Energy Saver
mode 1.
This setting cannot be disabled.
• On (1 to 60 minutes)
• 30 sec.
Default: [30 sec.]
Administrator Tools Settings
243