Authentication Information
193
7
Registering a User Code
This section describes how to register a user code.
A Press [System Settings].
B Press [Administrator Tools].
C Press [TNext].
D Press [Address Book Management].
E Check that [Program / Change] is selected.
F Press the name whose code is to be registered, or enter the registered num-
ber using the number key.
If you press , you can search by the registered name, user code, fax number,
folder name, e-mail address, or IP-Fax destination.
G Press [Auth. Info].
H Enter the user code using the number keys, and then press the {q} key.
If you make a mistake, press [Clear] or the {Clear/Stop} key.
I Press [TNext] twice.
J Select the functions to be used with the user code from Available Func-
tions.
K Press [OK].
To continue registering user codes, repeat the procedure from step
F
.
L Press [Exit].
To Next Page
Loading...
