Interface Settings
51
2
❖ Ping Command
Check the network connection with ping command using given IP address.
If you fail to connect to the network, check the following, and then retry the
ping command.
• Make sure that “TCP/IP” in [Effective Protocol] is set to “Effective”.
• Check that the machine with assigned IP address is connected to the net-
work.
• There is a possibility that the same IP address is used for the specified
equipment.
❖ Permit SNMP V3 Communication
Set the encrypted communication of SNMPv3.
The default setting is Encryption / Clear Text.
If you select to [Encryption Only], you need to set an encryption password for
the machine.
❖ Permit SSL / TLS Communication
Set the encrypted communication of SSL / TLS.
The default setting is Ciphertext Priority.
If you set to [Ciphertext Only], you need to install the SSL certificate for the ma-
chine.
❖ Host Name
Specify the host name.
Enter the host name using up to 63 characters.
❖ Machine Name
Specify the machine name.
Enter the machine name using up to 31 characters.
To Next Page
Loading...
