PaperCut – Ricoh Embedded Manual Revision: 19 2012-10-26
Copyright © 2012 PaperCut Software International Pty. Ltd., All Rights Reserved. 17 of 41
9. The PaperCut application then attempts to connect to the PaperCut server. If it
successfully connects to the server, you will be presented with the “Welcome screen”
(see below).
10. The Ricoh device will appear in the PaperCut administration interface under the
“Devices” tab with the name you provided in the steps above. It will be created using
the cost settings of the “[Template Printer]”.
The embedded application is configured to “auto-start” which means that when the MFP
device is rebooted/restarted the PaperCut application will start automatically.
The embedded application is now successfully installed. To use the photocopier, the
users must login to the application, and any copying they perform is logged in PaperCut.
To Next Page
Loading...
Need help?
General Specifications
