Ricoh Aficio MP C2050 User Manual

PaperCut – Ricoh Embedded Manual Revision: 19 2012-10-26
Copyright © 2012 PaperCut Software International Pty. Ltd., All Rights Reserved. 4 of 41
2 Installation
This section covers the installation of the PaperCut embedded application for compatible
Ricoh devices. The embedded application will allow the control, logging and monitoring of
walk-up off-the-glass copier, scan and fax usage and may serve as a release station for
network prints (for information on just tracking network printing see the PaperCut user
manual).
2.1 Requirements
Ensure that the following points are checked off before getting started:
 PaperCut is installed and running on your network. Please see the ‘Installation’
section of the PaperCut user manual for assistance.
 Ensure that your Ricoh device supports ESA SDK version 2 or later. Check the
device lists in 2.1.1 and 2.1.3 below.
 Ensure you know which SDK version your device supports. Installation instructions
will vary slightly for different SDKs.
 Ensure that the Java card is installed. (This must be purchased and installed by a
Ricoh dealer).
 For SDK version 4 (or later) devices, the System Parameter SP-5113-2 must be set
to “Expansion Device 1”. NOTE: This setting can only be changed by a Ricoh
Technician. We recommend getting this changed when the Java card is
installed.
 For devices prior to SDK 10.0, verify that the “Other Function” button is installed on
the left of the Ricoh LCD screen (this is below the Copy/Fax/Scanner buttons – see
screenshot below). This button will activate the PaperCut embedded application and
is usually installed by a Ricoh technician when the Java card is installed. The “Other
Function” button is installed underneath the other Copier, Fax, and Scanner buttons
on the left of the LCD screen.
Figure 1: Pre SDK 10 device showing "Other Function" button

Ricoh Aficio MP C2050 Specifications