PaperCut – Ricoh Embedded Manual Revision: 19 2012-10-26
Copyright © 2012 PaperCut Software International Pty. Ltd., All Rights Reserved. 23 of 41
4 Configuration
After completing the Installation section and registering the device with PaperCut, it will have
been configured with reasonable default settings that are suitable for most environments.
This section covers how to change the default settings. All the following settings are
available via the device’s ‘Summary’ tab in the PaperCut administration interface.
4.1 Device Function
The device function setting defines which functions will be available on the device and how it
will be used. Not all function settings are supported on all devices.
Each device function is discussed in the following table.
The device will be available for tracking walk-up off-the-glass
copying.
The device will be available as a print release station.
The device will be available for tracking scanning.
(supported on devices supporting SDK 4 or higher)
The device will be available for tracking faxing.
(Supported on devices supporting SDK 4 or higher. See section
6 for more information.)
4.2 Authentication Methods
PaperCut supports a number of different ways to authenticate users who walk-up to the
devices to perform copying. The default authentication method is username and password
authentication.
The available authentication methods can be modified in the ‘External Device Settings ->
Authentication methods’ section.
To Next Page
Loading...
