Troubleshooting When Using the Printer Function
50
4
Alert Messages
This section describes the machine alert messages.
Message Cause Solution
Cannot connect
with the wire-
less card. Turn
the main power
switch off, then
check the card.
/
Problems with
the wireless
card.
/ Problems
with the wire-
less board.
• IEEE 802.11b interface unit
was not inserted when the
machine was turned on, or it
was pulled out after the ma-
chine turned on.
• The settings are not updated
although the unit is detected,
or errors are found while ac-
cessing the unit.
Turn off the machine and check
the IEEE 802.11b interface unit is
inserted correctly. Then, turn the
machine on again. If the message
appears again, call your service
representative.
Problems with
IEEE 1394 Board.
An error may have occurred in
the IEEE 1394 board.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
LProblem with
Hard Disk.
An error has occurred in the hard
disk drive.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
The entered
password is in-
correct.
The password of the encrypted
PDF file has been entered incor-
rectly.
Enter the correct password.
USB has a prob-
lem.
An error has occurred in the USB
interface.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Hardware Prob-
lem: Ethernet
An error has occurred in the Eth-
ernet board.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
You do not have
the privileges
to use this
function.
Use of this function is restricted. Contact the administrator.
To Next Page
Loading...
