Troubleshooting When Using the Copy Function
26
2
When Memory is Full
This section explains likely causes of and possible solutions for problems related
to full memory.
Note
❒ If you set [Memory Full Auto Scan Restart] in User Tools to [On], even if the mem-
ory becomes full, the memory overflow message will not be displayed. The
machine will make copies of the scanned originals first, then automatically
proceed scanning and copying the remaining originals. In this case, the result-
ing sorted pages will not be sequential. See "Input / Output", General Settings
Guide.
Message Cause Solution
Memory is full.
nn originals
have been
scanned.Press
[Print] to copy
scanned origi-
nals. Do not re-
move remaining
originals.
The scanned originals exceeds
the number of pages that can be
stored in memory.
Press [Cancel] to copy scanned
originals and cancel the scanning
data. Press [Clear Memory] to can-
cel the scanning data and not
copy.
Press [Resume]
to scan and copy
remaining origi-
nals.
The machine checked if the re-
maining originals should be cop-
ied, after the scanned originals
was printed.
To continue copying, remove all
copies, and then press [Resume
Printing]. To stop copying, press
[Cancel].
To Next Page
Loading...
