Adding Paper, Toner and Staples
80
6
Loading Paper into the Paper Trays
The following procedure explains loading paper (in paper tray 2 as an example).
Important
❒ Tray 1 uses only A4 K paper. If you want to load 8
1
/
2
" × 11" K, contact your
service representative.
❒ The position of the side and end fences can be changed in tray 2, 1 tray paper
unit, and 2 tray paper unit. Paper of various sizes can then be loaded in them.
When changing paper size, see "Changing the Paper Size".
❒ Do not stack paper over the limit mark.
A Carefully pull out the paper tray until it stops.
B Square the paper and load it print side up.
AMJ001S
AMJ002S
To Next Page
Loading...
