Troubleshooting When Using the Printer Function
58
4
White lines ap-
pear.
When D is blink-
ing, toner is be-
ginning to run
out.
Add toner. See p.90 “Adding Toner”.
When printing
graphics, the out-
put and the
screen are differ-
ent.
If the printer
driver is config-
ured to use the
graphics com-
mand, the graph-
ics command
from the ma-
chine is used to
print.
If you want to print accurately, set the printer driver to
print without using the graphics command. See the
printer driver Help.
Garbled charac-
ters are printed.
The correct print-
er language
might have not
been selected.
Set the correct printer language.
Images are print-
ed in the wrong
orientation.
The feed orienta-
tion you selected
and the feed ori-
entation selected
in the printer
driver's option
setup might not
be the same.
Set the machine's feed orientation and the printer driv-
er's feed orientation accordingly. See the printer driver
Help.
There is consid-
erable delay be-
tween the print
start instruction
and actual print-
ing.
"Off mode /
Sleep mode"
might be set.
The machine requires time to warm up if it has been in
"Off mode/Sleep mode". Specify "Off mode/Sleep
mode" in [System Settings], [Auto Off Timer].
Problem Cause Solution
To Next Page
Loading...
