7. Replace the originals that you were copying, and then press the [Start] key.
Following the instructions on the display.
• The previous copy job settings are restored. Simply press the [Start] key to continue copying from
where it left off.
Auto Start
If you make settings and scan originals while the machine is busy, your copies will be made once the
machine is ready.
1. Make your settings while "Select copy mode and press the Start key." and "Scanning
originals can be started." are displayed alternately.
2. Place the original.
3. Press the [Start] key.
The machine scans the original.
Copying starts automatically once the machine is ready.
Job Preset
You can make settings for the next copy job during copying.
If a long copy job is in progress and you do not want to wait for it to finish, you can use this function to set
up the next copy job in advance. When the current copy job is finished, the next job will start automatically.
1. Press [New Job] when "Copying..." appears.
2. Be sure message "Ready" appears, and then make settings for the next copy job.
3. Place the originals, and then press the [Start] key.
All originals are scanned.
When the preset job is complete, a job preset confirmation dialog box appears.
2. Basic Copying
40
To Next Page
Loading...
