Input/Output
93
3
Input/Output
This section describes the user tools in the Input/Output menu under Copier /
Document Server Features.
Default settings are shown in bold type.
❖ Switch to Batch
You can select to have Batch mode or SADF mode displayed when you press
the [Special Original] key.
The default setting is Batch.
❖ SADF Auto Reset
When you set one original at a time in the ADF, the Auto Feed indicator lights
for a specified time after an original is fed, to show the ADF is ready for an-
other original.
You can adjust this time from 3 to 99 seconds in increments of 1 second.
The default setting is 5 seconds.
❖ Rotate Sort: Auto Paper Continue
Specify to continue copying when paper of the required orientation has run
out during rotate sort.
The default setting is No.
•Yes
Copying continues using copy paper of a different orientation. The copy
job will finish even if you have left the machine.
•No
When paper of the required orientation runs out, the machine stops copy-
ing and prompts you to supply copy paper. After you have loaded paper,
the machine will continue copying.
❖ Auto Sort
You can specify whether the Sort function is selected when the machine is
turned on, or the functions are cleared.
The default setting is No.
❖ Memory Full Auto Scan Restart
When memory becomes full while scanning originals, the machine can make
copies of scanned originals first, and then automatically proceed scanning re-
maining originals.
The default setting is No.
•Yes
You can leave the machine unattended to make copies, but sorted pages
will not be sequential.
•No
When memory becomes full, the machine stops operation allowing you to
remove the copy pages delivered on the output tray.
To Next Page
Loading...
Need help?
General
