Copier / Document Server Features
82
3
Reproduction Ratio
This section describes the user tools in the Reproduction Ratio menu under
Copier / Document Server Features.
Default settings are shown in bold type.
❖ Shortcut R / E
You can register up to three frequently used Reduce/Enlarge ratios other
than the fixed Reduce/Enlarge ratio and have them shown on the initial dis-
play. You can also change registered Reduce/Enlarge ratios.
If no Reduce/Enlarge ratio has been set when selecting [Shortcut R / E 1], [Short-
cut R / E 2], or [Shortcut R / E 3], enter the ratio using the number keys.
❖ Enlarge 1-5
You can customize available enlargement ratios by pressing [Reduce / Enlarge],
followed by [Enlarge].
The default setting for "Enlarge 1" is 115% (Metric version) / 121% (Inch version).
The default setting for "Enlarge 2" is 122% (Metric version) / 129% (Inch version).
The default setting for "Enlarge 3" is 141% (Metric version) / 155% (Inch version).
The default setting for "Enlarge 4" is 200% (Metric version) / 200% (Inch version).
The default setting for "Enlarge 5" is 400% (Metric version) / 400% (Inch version).
When selecting [User Enlrg. Ratio], enter a ratio using the number keys (in the
range of 101 to 400%).
❖ Priority Setting: Enlarge
You can set the ratio with priority when [Reduce / Enlarge] is pressed, followed
by [Enlarge].
The default setting is 141% (Metric version) / 155% (Inch version).
Enlarge1 Enlarge2 Enlarge3 Enlarge4 Enlarge5
To Next Page
Loading...
Need help?
General
