Guide to Components
19
1
11. Control panel
See “Control Panel”.
12. {Scanner Stop} key
Use if originals are feeding in slanted, or
to cancel scanning while an original is
feeding in.
13. Original guide
Set to the width of your originals.
14. Original table
Place originals here scanning side down.
15. Main unit front cover
Open when toner runs out.
16. Bypass tray
Use to feed paper in manually. Load pa-
per print side up.
17. Bypass tray's paper guide
Set to the width of the paper for bypass
copying.
18. Cut paper tray (optional)
Load cut paper here.
19. Lower output stacker
When the lower output is selected, out-
put paper is stacked here.
20. Lower output auxiliary guide
Pull this out to insert rolled paper or long
originals.
Note
❒ Do not pull out the lower output auxiliary guide when lower output is select-
ed. Otherwise, output paper may not be stacked properly.
To Next Page
Loading...
