Guide to Components
23
1
❖ Paper roll tray
This illustration shows the paper roll tray 2.
1. Paper roll 1
2. Paper roll 2
3. Cutter knob
Use to manually cut paper if there are
paper jams in the cutter area of the
machine. Always return the cutter
knob to the left or right end.
4. Paper holder
The two paper holders grip the paper
roll and are mounted on the paper roll
tray's roll holder.
5. Paper feed knob
Use when loading paper rolls or clear-
ing paper jams.
6. Roll holder
Adjust this to the size of the paper roll
you are using.
Note
❒ The paper roll tray is required to install the cut paper tray.
❒ If the rear stacker is installed, the lower output stacker, lower output tray,
lower output guides, and folding finisher cannot be used.
Reference
p.23 “Other Options”
p.61 “Roll Feeder Type 240 A or 240 B”
“Loading Paper”, Troubleshooting
“Clearing Misfeeds”, Troubleshooting
“Changing the Paper Size in the Paper Roll Tray”, Troubleshooting
Other Options
This section provides explanations about other options.
•Printer unit
Allows you to use the printer function.
You can install either Type W3600 or RW-3600 printer unit.
•Scanner unit
Allows you to use the scanner function.
ATZ068S
To Next Page
Loading...
